how to reset networx nx8 v2 to factory defaults

How to reset networx nx8 v2 to factory defaults install#

Installation Guidelines Use the following guidelines when installing receiver modules: ■ ■ ■ Do not tighten the standoff at this time.

How to reset networx nx8 v2 to factory defaults install#

Install the circuit board edge guide standoff in the lower mounting hole, in either of the two spaces located just to the left of the NX-8 motherboard (see Figure 2). Installing the Ground Plane Screws, Washers, and Nuts 2) The receiver modules mount inside the NX-8 cabinet and require just three wire connections for power and data communications to the NX-8 motherboard.įigure 1.

Adding a receiver module makes NX-8 control panels compatible with NX wireless transmitters and keychain touchpads (keyfobs). Installation Instructions Product Summary The NX-Series Receiver Modules (8-zone NX-408, 16-zone NX-416, and 48-zone NX-448) add wireless capabilities to the Caddx® NetworX NX-8 control panel. E August 1998 1)Īfter mounting the NX-8 cabinet, install the ground plane screws, washers, and nuts (included) in the holes on top of the cabinet (see Figure 1). 1420 North Main Street Gladewater, Texas 75647 Toll Free: 1-80 FAX: (903) 845-6811 Caddx is a registered trademark of Caddx Controls, Inc.įor reprints of this package, order part number 466-1486. Caddx® Installation Instructions Package This package includes instructions for the following Caddx products: ■ ■ ■ ■ ■